| News | Cooperation | Help | Company | Contact | | £ | | | Kr.
   
Register   Forgot your password?
Login: Password:    
NEWS & PROMOTIONS
PRINTSHOP
PRINT ON DEMAND
STICKERS & LABELS
PLOTER SERVICES
PROMOTIONAL GADGETS
PACKING & ADV STANDS
SAMPLES

News

 
Sizes
Final Trim Size
Maximum final trim size should not exceed 1250 x 2480 and is limited by the size of the selected material (see the referenced table for media sizes).

Minimum final trim size is 100mm x 100mm.
Full Bleed Size
The artwork should consist of a single-page file with trim and/or crop marks (crop marks are produced using a 90° cone cutter – they facilitate material folding).
Prepare the artwork without register marks and fill the area representing the printed pieces with a uniform colour – 100% Cyan (so that the operator can distinguish a printed piece from the waste material). Trim and/or crop marks must be visible (move them to the top).
Please note: if there are several objects to be trimmed in one file, trim marks should be at least 10 mm apart.

The cutting plan should be designed as the front side of the finished piece (important for single-sided materials and in case of cutting)

      projekt rozkroju   ->   gotowy produkt 


Trim and crop marks
Trim marks and any aperture outlines should be marked with a black hairline (100% M + 100% Y), while crop marks should be designed as brown hairlines (60% M + 60% Y + 40% B).

We use one of the following technologies for trimming and/or cropping, depending on the selected material: a knife or a milling cutter. When designing trim marks, please follow the instructions for the selected material:
MaterialTrimming technologyMinimum curve radius (R) mmInner verticesOuter vertices
PCV 2-3mm knife6 acceptableacceptable
Kappa 5mm knife10 acceptableacceptable
Kappa 10mm knife15 acceptableacceptable
Tusand 10mm knife15 acceptableacceptable
Other materialsfrez 4 unacceptableacceptable
Please note: trim marks that are not designed according to the above instruction may cause tearing of the edges.

Considering the duration of trimming, while designing:
- You should use straight lines instead of curved lines wherever it is possible.
- You should not increase the number of vertices more than necessary for the delineation of the curve.
- You should try to connect lines in such way that there would be only a few long, connected lines instead of many short lines in your artwork.
- Trim marks cannot overlap.
- Trim marks must take on the form of closed lines.

Please note!
If, due to the complexity of shape or non-optimal preparation of a file, the plotter operation time increases significantly, D&D reserves the right to change the price. The client will be informed of this before the job is carried out.


Saving to File
File Formats
Preferred: PDF
Accepted: CDR, TIFF, JPG (not recommended). 
Please note: In case of INDESIGN software, we accept only PostScript files. Otherwise, please use the Comment section to inform us: "Attention: InDesign file. Convert to PS, please".  CDR
Accepted:  PDF, DXF


By continuing to use our website, you accept and agree to be bound by our Terms and Conditions, Privacy Policy and the use of cookies.

Our website uses information supplied by cookies necessary to use our online store and generate statistics.
If you use our website without adjusting the settings of your browser, cookies will be stored in your device.
Please remember that you can always adjust your browser settings.